Generally speaking, the service life of wires and new energy cables is not less than 20 years, but external factors often affect their service life, such as insulation layer damage, aging, corrosion, etc. In actual use, the reasons for the aging of new energy cables are various, so how to extend the service life of new energy cables? The service life of the wire depends on the quality of the wire and the environment where the wire is installed and used. The wire mainly relies on the outer layer of insulation. For a long time, they are corroded by corrosive gases. The insulation performance is gradually reduced, aging hardens, becomes brittle or falls off. At this point, they are not insulating. The insulation layer on the outer surface of household wires is mostly made of plastic and rubber, which will age and lose the insulation effect after a long time of use. It is very dangerous for wires to lose their insulation properties. If the two wires touch together or the live wire touches something connected to the earth, a power run will occur, causing the temperature of the local wire to rise, causing sparks and accidents. Therefore, you can pay attention to the following points during use, which can also effectively prolong the service life of new energy cables: 1. Avoid man-made damage. The wires laid directly on the outer wall must be careful not to be artificially damaged. The wire is mainly insulated by the outer insulation layer. As wires age, harden, become brittle, or fall off, the surface insulation performance degrades. 2. Pay attention to moisture-proof. Wires and new energy cables should be protected from moisture. When it is wet, it is easier to short-circuit and leak electricity when the water penetrates into the metal conductor, which not only affects the service life of the wire, but also easily causes accidents. 3. Prevent sun exposure and aging. There are many local area network new energy cables under the eaves. At this time, be careful not to expose them to the sun, and the ambient temperature should not be too high. Because ultraviolet radiation will accelerate the aging of new energy cables, thereby shortening the service life. 4. Pay attention to storage. When storing wires, it is strictly forbidden to contact with acids, alkalis, and mineral oils, and to isolate them from these corrosive substances. Try to avoid exposing new energy cables in the open air. 5. Periodic inspection. During normal use, the use of household electrical appliances and lines should be checked regularly, and maintenance, maintenance and replacement should be carried out in a timely manner. .
Recommend: