EVCOME EV charging stations for better life---Top EV charging stations manufacturers & suppliers in China.
Language
EVCOME EV charging stations for better life---Top EV charging stations manufacturers & suppliers in China.
The charging pile is fixed on the ground, uses the special charging interface, and adopts the conduction method to provide AC power for the electric vehicle with the on-board charger. It has corresponding communication, billing and safety protection functions of the charging pile manufacturer. Citizens only need to buy an IC card and recharge it. , you can use the charging pile to charge the car. After the electric vehicle battery is discharged, use direct current to pass through the battery in the opposite direction to the discharge current to restore its working ability. This process is called battery charging. The negative pole of the energy charging pile manufacturer is connected to the negative pole of the power supply, and the voltage of the charging power supply must be higher than the total electromotive force of the battery. The constant current charging method is to adjust the output voltage of the charging device or change the resistance of the charging pile connected in series with the battery to keep the charging current intensity constant. The control method is simple, but because the acceptable current capacity of the battery changes with the charging As the process progresses, it gradually decreases. In the later stage of charging, the charging current is mostly used for electrolyzing water, generating gas, and causing excessive gas output. Therefore, the stage charging method is often used. The voltage of the charging power source maintains a constant value during the entire charging time of the car charging pile. As the battery terminal voltage gradually increases, the current gradually decreases. Compared with the constant current charging method, the charging process is closer to the optimal charging curve. The electric vehicle charging pile line is fast charged with a constant voltage. Due to the low electromotive force of the battery at the initial stage of charging, the charging current is very large. As the charging progresses, the current will gradually decrease. Therefore, only a simple charging pile solution is required to control the system. Usually we basically use household electricity when using charging piles, so how about using household electricity in terms of safety and economy? Charging pile OEM. First of all, it is necessary to determine whether it is suitable to use household electricity according to the technical parameters of the supporting charging pile for the car.“Voltage”,“power”These two points, on the one hand, the custom-made charging pile charging pile has a large charging power for new energy vehicles, and the charging time is long, which will affect the use of other electrical facilities in your home. Therefore, we must also consider household electricity when using charging piles. The ODM quantity of charging piles can avoid the problem of power overload. The second is the more important issue of electricity bills. The State Grid must be, but we basically cannot use the State Grid. On the one hand, there is no interface. If you need to install the interface, you need to use special equipment, which consumes a lot. At the same time, electricity prices in different provinces and cities are different. different, and“Peak and valley electricity price”,“Ladder price”Billing method, charging pile OEM.
Recommend:EV Charging Cable
EV Charger Connectors
