EVCOME EV charging stations for better life---Top EV charging stations manufacturers & suppliers in China.
Language
EVCOME EV charging stations for better life---Top EV charging stations manufacturers & suppliers in China.
evcome Wire New Energy Cable Co., Ltd. is a collection of R&D. A large-scale professional wire and new energy cable enterprise integrating manufacturing and sales. Introduce advanced wire and new energy cable manufacturing technology, production equipment and testing equipment, including imported wire drawing equipment, imported automatic shaker packaging equipment, advanced granulation production equipment, automatic granulation pipeline transportation system, etc. And introduce the industry's advanced cross-linked wire new energy cable production line, medium and low voltage wire new energy cable production line, etc. ;At the same time, specializing in the production of new energy cables for electric power, new energy cables for home improvement, TV cables, control cables, special new energy cables, flame-retardant new energy cables, fire-resistant new energy cables, low-smoke and halogen-free new energy cables, and termite-proof new energy cables , Mineral insulated new energy cables, etc. We have rich experience in wire and new energy cable operation. The sheath of electric wire and new energy cable products is mostly environmentally friendly plastic (PVC) or rubber. When the outer skin is below zero, it will harden, and the wires of the entire wire and new energy cable product will become hard and brittle, causing the outer skin to fall off and be damaged under a slight external force. Therefore, especially in the north, new energy cable protection should pay attention to the following points: 1. Mobile transportation. Warmth and protection are required, both on the move and when the product is factory loaded onto the carrier. For example, use a closed carrier to prevent direct exposure of the product; put a layer of cushions on the product, such as bedding or other soft foam; when moving the load, do not load it roughly to avoid excessive bending of the product. When arriving at the destination or the construction site, it is best for the product supplier to send personnel to supervise to prevent rough operation when the product is unloaded. 2. Storage It is best to store the product indoors, and at the same time lay a layer of isolation layer on the storage surface, such as wood, bedding, foam, etc., to prevent the product from freezing and wet, and pay attention to prevent the product from directly contacting the ground and scraping the skin of wires and new energy cables. Put it lightly. 3. Product laying and installation. It is best to choose to work in the warm midday and afternoon. If possible, heaters and other equipment can be used to“warm up”product for optimum performance. If it is buried underground, a protective layer, such as fabric, foam, etc., can be laid in the new energy cable trench in advance. If running through a pipe, first make sure the pipe is smooth inside and out so you don't scratch the wires. Special attention should be paid to iron pipes. Select qualified iron pipes. Poor quality iron pipes may have a large number of sharp raised points, which may scratch the skin of the wire. When working outdoors below zero, carefully check whether the new energy cables are in good condition after installation. If the new energy cable products go wrong, the consequences of the impact are often more serious. We should do frequent and regular line safety checks. For wires, electrical equipment, etc., professional personnel should be invited to conduct a comprehensive and thorough inspection at least once a year, especially for lines with long service life of connectors. If unsafe conditions such as aging, damage, and poor insulation of wires are found, they should be repaired and replaced in time to ensure power consumption. Safety. Therefore, to prevent unburned, strive to do every detail well. .
Recommend:
